Integra DTR-40.5, Instruction Manual

Page: 49 / 104

Playback
En-49
When you connect an
u
-capable Integra/Onkyo
component, you must configure the input display so
that
u
can work properly.
This setting can be done only from the front panel.
You can temporarily mute the output of the AV
receiver.
The Whole House Mode is useful when you want to
add extra background music to your home party; this
allows you to enjoy the same stereo music as the
main room in separate rooms (Zone 2/3).
The Whole House Mode selects the same input
source for Multi Zone as the main room’s.
See also:
• “2. Speaker Setup” (
➔
page 58 )
• “Multi Zone” (
➔
page 75 )
Changing the Input Display
1
Press TV/CD or Game.
“ TV/CD ” or “ GAME ” appears on the AV receiver’s
display.
2 Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input
display.
Note
“
• “ DOCK ” can be selected for the “ TV/CD ” or “ GAME ”
input selector, but not at the same time.
• Enter the appropriate remote control code before using
the remote controller for the first time (
➔
page 80 ).
Muting the AV Receiver
1
Press Receiver followed by Muting.
The output is muted and the MUTING indicator
flashes on the AV receiver’s display.
Tip
• To unmute, press Muting again or adjust the volume.
• Muting is automatically cancelled when the AV
receiver is set to standby.
TV/CD
→
DOCK
→
→
TAPE
■
TV/CD:
GAME
↔
DOCK
■
Game:
Using the Whole House Mode
1 Press Whole House Mode on the front panel.
To cancel the Whole House Mode, press Off ,
change the input source for the main room, or
select a listening mode (
➔
page 40 ).
Note
• The Whole House Mode only supports analog audio
and audio from NET or USB input selector.
• To adjust the volume of Multi Zone, switch the AV
receiver to Multi Zone control. See “Adjusting the
Volume for Zones” (
➔
page 76 ) for the volume
adjustment of Multi Zone.
• The Whole House Mode is not available in either of the
following cases:
– The “
Audio TV Out (Main) ” setting is set to “ On ”
(
➔
page 71 ) or “ Audio TV Out (Sub) ” setting is set
to “ On ” (
➔
page 71 ) and you’re listening through
your TV speakers.
– “ HDMI CEC (RIHD) ” is set to “ On ” (
➔
page 70 ) and
you’re listening through your TV speakers.
– a pair of headphones is connected.