Integra DTR-40.5, Instruction Manual

Page: 66 / 104

Advanced Operations
En-66
Operating
procedure
(
➔
page 55 )
■
Picture Mode
*1
`
Custom :
All settings can be performed manually.
`
Cinema :
Select when the picture source is a movie or
alike.
`
Game :
Select when the video source is a game
console.
`
Standard :
Does not adjust picture quality (changes
resolution).
`
Bypass :
Does not adjust picture quality (does not change
resolution).
With “ Picture Mode ”, you can change the following
settings to be suitable for the movie or game screen
by one operation: “
Game Mode ”, “ Film Mode ”, “ Edge
Enhancement ”, “ Noise Reduction ”, “ Brightness ”,
“ Contrast ”, “ Hue ”, “ Saturation ” or “ Color
Temperature ”.
■
Game Mode
*2*3*4
`
Off
`
On
If video signal delay occurs during playback on a video
component (i.e., game console), select the
corresponding input source and set the “
Game Mode ”
setting to “ On ”. The delay will decrease but in return
the picture quality will become poor.
■
Film Mode
*2*4
`
Video :
“ Film Mode ” detection is not applied and the
input signal is handled as a video source.
`
Auto :
Detects whether the input signal is a video or a
movie. If it is a movie, the appropriate
conversion is applied.
The AV receiver will adjust to the picture source,
automatically converting it to the appropriate
progressive signal and reproducing the natural quality
of the original picture.
■
Edge Enhancement
*2*4*5
`
Off
`
Low
`
Mid
`
High
With this setting, you can make the picture appear
sharper.
■
Noise Reduction
*2*4*5
`
Off
`
Low
`
Mid
`
High
With this setting, you can reduce noise appearing on
the screen. Select the desired level.
■
Brightness
*1*2*4
`
–50 to 0 to +50
With this setting, you can adjust the picture
brightness. “
–50 ” is the darkest. “ +50 ” is the brightest.
■
Contrast
*1*2*4
`
–50 to 0 to +50
With this setting, you can adjust contrast. “ –50 ” is the
least. “ +50 ” is the greatest.
■
Hue
*1*2*4
`
–50 to 0 to +50
With this setting, you can adjust the color hue
between “
–50 ” and “ +50 ”.
■
Saturation
*1*2*4
`
–50 to 0 to +50
With this setting, you can adjust saturation. “ –50 ” is
the weakest color. “ +50 ” is the strongest color.
■
Color Temperature
*2*4
`
Warm
`
Normal
`
Cool
With this setting, you can adjust the color
temperature.
Note
• “ Picture Adjust ”
cannot be used when:
– The “ NET ”, “ USB ” or “ BLUETOOTH ” input selector is
selected, or
– “ Monitor Out ” is set to “ Sub ”.
*1 This procedure can also be performed on the remote
controller by using the Quick Setup (
➔
page 51 ).
*2 When the “ Picture Mode ” setting is set to anything other
than “ Custom ”, this setting cannot be used.
*3 If the “ Resolution ” setting is set to “ 4K ” (
➔
page 56 ),
this setting is fixed at “ Off ”.
*4
Press CLR if you want to reset to the default value.
*5 If the “ Game Mode ” setting is set to “ On ”, this setting is
fixed at “ Off ”.
*6 When a 3D video source is input, “ Wide Mode ” is fixed to
“ Full ”.