Integra DTR-40.5, Instruction Manual

Page: 77 / 104

Advanced Operations
En-77
Note
• Only analog, NET or USB input source is output from the
ZONE 2/ZONE 3 PRE/LINE OUT jacks and ZONE 2 L/R
terminals.
• You cannot select different AM or FM radio stations for your
main room and Zone 2/3. The same AM/FM radio station
will be heard in each room. Namely, if you have selected an
FM station for the main room, that station will also be output
in Zone 2/3.
• You cannot select different input selector NET or USB for
your main room and Zone 2/3. Namely, if you have selected
USB input selector for Zone 2/3, USB input selector will be
selected in main room even if NET has been selected for
main room.
• “ BLUETOOTH ” cannot be selected as input selector in
Multi Zone. If you play audio from Bluetooth-enabled device
in Multi Zone, select “
Z2 Sel: Source ” or “ Z3 Sel: Source ”,
and “ BLUETOOTH ” as input selector in Main room.
• When Zone 2/3 is activated and its input selector is
selected, the power consumption of standby mode slightly
increases.
• While Zone 2/3 is on, u functions will not work.
• When setting the AV receiver to standby mode while Zone
2/3 is active, the Z2 or Z3 indicator is dimly lit.
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE/LINE OUT jacks when the
“ Zone 2 Out ” setting is set to “ Fixed ” (
➔
page 69 ).
• The Zone 3 volume function has no effect on ZONE 3
PRE/LINE OUT when the “ Zone 3 Out ” setting is set to
“ Fixed ” (
➔
page 69 ).
The 12V triggers A, B, and C can be used to turn on
12V trigger-capable components automatically when
they are selected as the input source. The triggers
can be set so that they activate themselves once a
connected component is selected as the input source
for the main room, Zone 2, Zone 3, or any
combination of rooms. When triggered, the output
from a
12V TRIGGER OUT goes high (+12 volts and
150 milliamperes max. at 12V TRIGGER OUT A ;
+12 volts and 25 milliamperes max. at 12V TRIGGER
OUT B and C ).
See “12V Trigger A/B/C Setup” (
➔
page 69 ).
Hookup
• Use a miniplug cable to connect the AV receiver’s
12V TRIGGER OUT A , B , or C jack to the 12 V
trigger input of a connected component.
Using the 12V Triggers