Integra DTR-30.5, Instruction Manual

Page: 73 / 96

Controlling Other Components
En-73
You can change the configuration of colored buttons,
with which
Remote Mode buttons are preset.
Tip
• To reset the Remote Mode buttons to their default settings,
see “Resetting the Remote Mode Buttons”.
Note
• If any other button than the colored buttons is pressed, the
operation will be cancelled.
• This operation cannot be done while the AV receiver is in
Receiver mode or when Zone 2 is active.
Integra/Onkyo components that are connected via
u are controlled by pointing the remote controller at
the AV receiver, not the component. This allows you
to control components that are out of view, in a rack,
for example.
Controlling Integra/Onkyo components without
u
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you
want to control an Integra/Onkyo component that’s
not connected via
u , use the following remote
control codes:
`
30627 :
Integra/Onkyo DVD player without u
`
71817 :
Integra/Onkyo CD player without
u
`
32900/33100/33500 :
Integra/Onkyo Blu-ray Disc player
`
32901/33104/33504 :
Integra/Onkyo HD DVD player
`
70868 :
Onkyo MD recorder without
u
`
71323 :
Onkyo CD recorder without u
`
82990 :
Onkyo Dock without
u
You can reset a Remote Mode button to its default
remote control code.
You can reset the remote controller to its default
settings.
Remapping Colored Buttons
1
While holding down the Remote Mode button
that you want to program, press and hold
down A (Red) until the remote indicator lights
(about 3 seconds).
You can only change colored buttons for
components whose codes belong to categories
of the Remote Control Codes list (BD/DVD
player, TV, cable set-top box, etc).
2 Within 30 seconds, press the colored buttons
in the order that you want to reassign them.
The button presses are assigned to each button
from left to right. The remote indicator flashes
twice, indicating that the sequence has been
successfully assigned. If the sequence is not
successfully assigned, the remote indicator will
flash once slowly.
Remote Control Codes for Integra/
Onkyo Components Connected via RI
1
Make sure the Integra/Onkyo component is
connected with an
u
cable and an analog
audio cable (RCA).
See “Connecting Integra/Onkyo RI Components”
for details (
➔
page 19 ).
2
Enter the appropriate remote control code for
a Remote Mode button, by referring to the
previous section.
`
42157 :
Onkyo cassette tape deck with
u
`
81993 :
Onkyo Dock with u
3 Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
Resetting the Remote Mode Buttons
1
While holding down the Remote Mode button
that you want to reset, press and hold down
Home until the remote indicator lights (about 3
seconds).
2 Within 30 seconds, press the Remote Mode
button again.
The remote indicator flashes twice, indicating that
the button has been reset.
Each
Remote Mode button is preprogrammed
with a remote control code. When a button is
reset, its preprogrammed code is restored.
Resetting the Remote Controller
1
While holding down Receiver, press and hold
down Home until the remote indicator lights
(about 3 seconds).
2 Within 30 seconds, press Receiver again.
The remote indicator flashes twice, indicating that
the remote controller has been reset.