Integra DBS-50.3, Instruction Manual

Page: 23 / 72

EN
23
ɶ Controlling AV Components that are Out-of-Range
You can use the following multi-room kits to control this unit when it’s out of range of the remote controller:
• Multiroom kits such as those made by Niles and Xantech.
Controlling Other Out-of-Range AV Components
If another AV component is out of range of its remote controller, you can use a commercially available IR emitter to
retransmit the remote controller signals received at this unit's IR IN jack, as shown below.
Signal flow
IR emitter
This unit
IR IN
IR OUT
Connecting block
Other
component
Remote controller
Connect the IR emitter to this unit’s IR OUT jack, and place the IR emitter in front of the other AV component’s
remote control sensor (usually located on its front panel), as shown below. See the instructions supplied with the IR
emitter.
Other component
Miniplug
from connecting block
Remote control sensor
IR emitter
Signal flow
Miniplug cable (not supplied)
IR emitter
Only remote controller signals received by this unit's IR IN jack are fed through to the IR OUT jack. Signals picked up by
this unit's remote control sensor are not output.
E5WF0UD̲EN̲Book.indb 23 2011/07/21 10:15:56