Functions
MoRoS LAN PRO 2.0
32
12.1.2
Configure IP Addresses or Retrieve via DHCP
It must be possible to access the MoRoS LAN PRO 2.0 in the LAN under a certain IP ad-
dress. You must assign a static IP address for this.
Configuration with the web interface
In order to configure a
static IP address
, change in the menu "Basic Settings"
to the page "IP address (LAN)".
Enter
the
IP address
of the MoRoS LAN PRO 2.0 in the LAN into the entry field
"IP address" and the
Subnet mask
into the field "Netmask address".
Save your settings by clicking "OK".
The
MAC address of the MoRoS LAN PRO 2.0
can be found in the entry fields
for the IP address and the network mask under "MAC address" on this page.
The link "Adjust DHCP server settings" at the end of the page remembers to
adjust these settings as well, if the IP address has been changed.
12.1.3
Enter Static Routes
You can define static routes for forwarding data packets in the MoRoS LAN PRO 2.0,
which are loaded during system start.
Configuration with the web interface
In order to enter a
static route
, change in the menu "Basic Settings" to the
page "Routing".
Enter
in the section "Add new route" the
Net address
, the
Netmask address
as
well as the
Gateway
into the respective fields.
In order to
delete an existing route
, check under "Existing routes" the check-
box of the route(s) to be deleted.
Save your settings by clicking "OK".
Neither a default gateway can be entered nor NAT can be enabled or dis-
abled here. This is configured for the respective interface in the menus
"Dial-In", "Dial-Out" or "Lan (ext)" on the respective page "Routing".
