AT Command Reference
i-modul Modem 336 LL
8
AT Command Reference
Command
Description
AT**
Start of the flash load function
A/
Repeat the last command
The last command is repeated.
AT\A<n>
Select maximum MNP block size
Define maximum block size for error corrected MNP transmissions.
AT\A0
64
byte
AT\A1
128 byte (default)
AT\A2
192
byte
AT\A3
256
byte
AT\B<n>
Send “break” to the other i-modul Modem 336 LL 3.0
For connections that were not error corrected, the i-modul Modem 336 LL 3.0
sends a break signal to the other i-modul Modem 336 LL 3.0. The length of the
signal is: the specified parameter times 1/10 of a second.
For error corrected connections, the i-modul Modem 336 LL 3.0 sends a break
signal according to the active error correction protocol without considering a pa-
rameter specification.
If no connection is established or if a fax connection is active, an error message is
displayed.
AT\B1
1/10 second break signal
AT\B2
2/10 second break signal
AT\B3
3/10 second break signal
AT\B4
4/10 second break signal
AT\B5
5/10 second break signal
AT\B6
6/10 second break signal
AT\B7
7/10 second break signal
AT\B8
8/10 second break signal
AT\B9
9/10 second break signal
AT%B<n>
Switch key abort on and off during connection
%B0
Key abort is active. Each character on the TX line will result in an
interruption of the connection setup.
%B1
Key abort is deactivated. A connection setup can not be inter-
rupted manually. A connection setup can only be terminated via
DTR drop, internal canceling of the i-modul Modem 336 LL 3.0 (
NO
DIALTONE, BUSY
) or Timeout (
NO CARRIER
). (S-Registry 36, Bit 6)
(default)
32
