Page 11 of 15 2342-x32 Rev: 11/20/2012 4:13 PM
Begin Bright
Press and hold
-
Single beep
Begin Dim
Press and hold
-
Single beep
Setup Action
Beeper
Enter setup mode, transition to next setup mode or exit
setup mode
Single beep
Setup successful, return to ready mode
Double-beep
Return to ready mode after a longer than 3 minute time-out
Long beep (3 seconds)
Failed to add scene responder
Long beep (3 seconds)
Exiting stuck button
Long beep (3 seconds)
LED Behavior during Setup
Mini Remote has a two-color LED (Green and Red) which displays helpful information.
LED State
Meaning
Blinking Green slowly
Add Responder Setup Mode, or
LED on/off Setup Mode
Blinking Red slowly
Remove Responder Setup Mode
Double-Blinking Green slowly
Multi-Add Responder Setup Mode, or
Beeper on/off Setup Mode
Double-Blinking Red slowly
Multi-Remove Responder Setup Mode, or
Keypad Configuration Setup Mode
Factory Reset
The factory reset procedure clears all settings from Mini Remote, including INSTEON scenes.
1) If possible, unlink (remove) all scene responders prior to performing factory reset
2) Turn Mini Remote off (slide power switch to left)
3) Press and hold set button
4) While continuing to hold the set button, turn Mini Remote back on (slide power switch to the right). Do
not release set button.
Mini Remote will beep
and LED will turn solid green
Mini Remote will emit a long beep
5) Continue holding set button until long beep stops, then release set button
LED will turn solid red
Mini Remote will double-beep and its LED will turn off
