Page 7 of 15 : 11/20/2012 4:14 PM
LED will begin blinking green
3) Press and hold Mini Remote set button until it beeps again
LED will begin blinking red
4) Press and hold responder set button until it double-beeps and/or its LED blinks
Mini Remote will double-beep and its LED will stop blinking
5) Confirm that scene removal was successful by tapping the Mini Remote paddle on/off
The responder will not respond
6) If you wish to add more responders to Mini Remote, repeat steps 1-5 for each additional scene
responder (or see
Remove Mini Remote as a Controller of Multiple Responders
)
Using Mini Remote
1 Scene Mode (Default)
The switch controls scene members as follows:
Paddle
Tap
Press and hold
Double-tap
Top
Turn scene on
Brighten until release
(dimmable responders only)
Instant full-on
Bottom
Turn scene off
Dim until release
(dimmable responders only)
Instant full-off
2 Scene Toggle Mode
The top and bottom paddle will control all its scene members as follows:
Last Command Sent
Tap
Press and hold
Double-tap
Off/Dim
Turn scene on
Brighten until release
(dimmable responders only)
Turn scene members full-
bright instantly
On/Bright
Turn scene off
Dim until release
(dimmable responders only)
Turn scene members off
instantly
2 Scene Non-Toggle Mode
(Always On)
Each button will control all its scene members as follows:
Tap
Press and hold
Double-tap
Turn scene on
Brighten until release
(dimmable responders only)
Turn scene members full-bright instantly
Note: Devices that respond to the scene trigger by turning off and non-dimmable devices will not respond
to dim and brighten commands.
