Page 4 of 14
2982-222 - Rev: 1/21/2014 8:34 AM
First Alert Setup
Pairing Smoke Bridge to First Alert Smoke Alarm
1) Press and hold Smoke Bridge set button until it beeps
Smoke Bridge LED will start blinking green
You will have four minutes to complete the next steps before linking mode times out
2) Press and hold First Alert Smoke Alarm test button until it beeps or says “testing”
First Alert Smoke Alarm will cycle through its test alert messages
Smoke Bridge LED will start blinking red, indicating traffic from the First Alert Smoke Alarm
Smoke Bridge LED will stop blinking when First Alert Smoke Alarm finishes sending message
3) Test pairing by pressing and holding Test button on First Alert Smoke Alarm
Smoke Bridge LED will blink red until the First Alert Smoke Alarm message is complete
INSTEON Setup
Some products have subtle differences in their setup procedures. Please refer to the other devices’
owner’s manuals for details.
INSTEON Controllers, Responders and Links
•
The INSTEON “transmitter” is called a
controller
•
The INSTEON “receiver” is called a
responder
•
The association between the controller and responder is called a
link
Note that a link is one way. If you wish to have control “the other way,” simply add a link “the other way.”
Configure INSTEON Settings
Most Smoke Bridge links and settings can be configured locally with the module’s Set button.
All Smoke Bridge settings can be managed remotely via software (sold separately).
Controller
Responder
Link
