Page 10 of 32 Rev: 10/13/2015 9:13 AM
Fan and Hold Button Operations
Fan button operations
•
The Fan button cycles between Auto and Always On.
•
On the display, it simply indicates the text “Fan Always” when selected. There is no indication for Fan
Auto.
Hold button operations
•
The Hold button overrides a preprogrammed mode until Hold is turned off.
NOTE:
•
While Hold is enabled, the next preprogrammed time that comes in Time of Day Mode will be ignored.
•
While Hold is enabled, the preprogrammed time notations are not shown (i.e. Wake, Leave, Return
and Sleep).
•
Hold can be remotely enabled/disabled from an Insteon controller.
Master Button Operation
First press and hold:
Makes the local Insteon Thermostat the master temperature controller
•
To perform this, press and hold Master button for 3 seconds.
Insteon Thermostat beeps once.
•
Release.
Note:
This is only valid if at least one Insteon Thermostat Zone Thermostat is linked to Insteon
Thermostat.
Before pressing Master button:
•
Notice that the left remote sensor is currently
the Master temperature controller.
After pressing and holding Master button:
•
Notice that the left remote sensor is no
longer the Master temperature controller.
•
The local Insteon Thermostat is now the
Master controlling temperature.
Note:
If no Insteon scene is programmed to a Insteon Wireless Thermostat, pressing and holding for 3
seconds will cause the Master segment to display while the button is being held.
Always On Auto
Hold On Hold Off