1. Introduction
Study this manual carefully and keep it with the
warranty documents. Connection must be carried
out by a qualified fitter in accordance with local
regulations. Before mounting or dismounting
the thermostat, always switch off the electricity
in the meter cupboard. This thermostat can be
mounted in a single flush-mounting box 50 mm
deep in accordance with standard DIN formats.
These regulations describe the C16 Basic and the
C16 WiFi version.
2. Technical Specifications
Voltage
: 230V - 50/60 Hz
Max. load
: Max. 16 Amp / 230V
Standby voltage
: C16 Basic: 1W / C16 WiFi: 2W
Temp. range
: +5/+40ºC
Housing
: IP21
Standard colour
: Polar white (RAL 9010)
Sensor
: Floor sensor and build in Air sensor
Warranty
: 2 years manufacturer’s warranty
Approvals
: FI / CE
Manufacturer
: MHGroup B.V. Netherlands
3. Assembly
1.
Press with your fingers at the top of the display and pull it towards you.
2.
Connect the thermostat according to the connection diagram (point 4).
3.
Mount the thermostat on the flush-mounting box.
4.
Put the frame on it and click the display back into place.
4. Wiring diagram
Connection must be carried out by a qualified fitter in accordance with local regulations.
Before mounting or dismounting the thermostat, always switch off the electricity in the
meter cupboard.
Recommendation: Keep the maximum load around 90% of the 16A to extend the service
life.
FLOOR SENSOR : Floor sensor connection
ROOM OUT SENSOR: External room sensor
connection
N1 Heating cable connection wire*
L1
Heating cable connection wire*
N
Power supply (Neutral)
L
Power supply (Phase)
EARTH : Connect the earth of the heating
cable and the earth of the power supply
outside the thermostat using the supplied
terminal block.
* Order L1 or N1 does not apply.
5. Explanation of symbols
When the thermostat is connected, turn the on/off switch down to turn the
thermostat on. The thermostat is operated by means of the 3 touch-sensitive buttons
on the bottom of the screen and has a series of fixed symbols in the display.
6. Startup menu
At the first startup, the following settings need to be entered. With the WiFi version it
will be updated automatically after connection.
Clock (CLK)
Choose Day Choose Hour
Choose Minutes
Sensor selection
(5 options)
1.
Floor sensor
2.
Room sensor
3.
Room sensor with floor sensor limit
4.
External room sensor
5.
External room sensor with floor sensor limit
3. Limit floor temperature
For tiled floors up to 35 degrees. PLEASE NOTE: For wooden floors set to a maximum
of 28 degrees!
4. Home or office situation (00 = Home, 01 = Office)
C16
WiFi / Basic
(WiFi) thermostat for electric floor heating
MAX LOAD: 16A
SENSOR
L1
N1 NL
FLOOR
SENSOR
POWER
85V-265V
50/60Hz
IP 21
N1
N
L
L1
S2 COM
S1
POWER
FLOOR SENSOR
ROOM -OUT SENSOR
Display
On/Off switch
Touch sensitive keys
86
86
59
51
52
24
9
12
1.
2.
3.
4.
Confirm (touch-sensitive key)
Down (touch-sensitive key)
Up (touch-sensitive key)
WiFi indicator
Hello
Clock
Room temperature
Floor temperature
Set up
Current temperature
Heating
Percentage
Current period (Smart Mode)
Key lock
Frost protection mode
Manual mode
Office
House
