Instanta InstaTap, Installation And User Instructions Manual

Page: 21 / 36

21
Installation instructions & user guide
T210042 InstaTap office manual v1.01 June 2022
SECTION 7 Commissioning
NOT
READY
o
C
HEATING
NOT
READY
o
C
HEATING
70
o
C
SOFT MEDIUM HARD
CHANGE FILTER
Pr
READY
o
C
96
CAUTION
HOT WATER
NOT
READY
o
C
96
CHECK
WATER
! !
CHANGE FILTER
NOT
READY
OF
! !
READY
CHECK
WATER
! !
READY
! !
CLEAN
PROBES
READY
MEDIUM
! !
NOT
READY
o
C
!
CHECK
WATER
READY
o
C
96
CAUTION
HOT WATER
• Flush the filter, and sanitise the system, see page 28.
• Turn on the mains water supply.
• Switch on the mains electricity supply.
• Using the chilled water button on the tap control panel, see page 25,
dispense 3 litres of water to prime and flush the UCC system.
• Wait 30 minutes , the fan and compressor will turn off indicating that the
UCC has reached its normal operating temperature and is ready for use.
7.1.2 Under counter chiller (UCC)
• When the programmed temperature has been
reached, READY, CAUTION HOT WATER, (TEMP)
O
C
is displayed.
• The red background illumination is extinguished.
• The tap controls illuminate.
• The UCB does not fill completely at once. The
water input is electronically controlled to obtain
maximum output, temperature and efficiency.
• Dispense (see page 24) 3 litres of water to flush the
UCB system.
• Wait again for the screen to read READY before
making a drink.
IMPORTANT NOTE In daily use you may use the appliance as soon as the
tap controls illuminate but on first installation wait at least 10 minutes
before starting to use the water.
NOT
READY
o
C
HEATING
NOT
READY
o
C
HEATING
70
o
C
SOFT MEDIUM HARD
CHANGE FILTER
Pr
READY
o
C
96
CAUTION
HOT WATER
NOT
READY
o
C
96
CHECK
WATER
! !
CHANGE FILTER
NOT
READY
OF
! !
READY
CHECK
WATER
! !
READY
! !
CLEAN
PROBES
READY
MEDIUM
! !
NOT
READY
o
C
!
CHECK
WATER
READY
o
C
96
CAUTION
HOT WATER
• To clear the warning, switch off the UCB mains
electricity supply, and then switch back on.
• When the water level reaches the boiler’s bottom
sensor, the heater is switched on.
• NOT READY, HEATING, -- O C is displayed.
• When the water temp is close to the programmed
temperature , the real time temperature is
displayed.