Insta360 Titan, User Manual

Page: 17 / 250

Charging with power off:
When the camera is not fully charged, the red power indicating lamp will go on.
When the camera is fully charged, the green power indicating lamp will go on.
Charging with power on:
When the electricity quantity of the camera is below 10%, the red power indicating lamp will go on until the low-point
protection is enabled or the camera is shut down upon exhaust of electricity;
When the electricity quantity of the camera is between 11% and 20%, the yellow power indicating lamp will go on;
When the electricity quantity of the camera is between 21% and 100%, the white power indicating lamp will go on;
When the camera operates, the work indicating lamp will be in the same color as the power indicating lamp. Refer to the
section about camera operation instructions for the flashing description of the work indicating amp.
Tip: With WiFi connection, Titan preview mode consumes more power, so please try to return to the homepage when
standby (as shown in the figure)
About real-time stitching and stitching calibration
Insta360 Titan has an accurate stitching parameter which can be used in most shooting scenarios. The stitching effect
shown on the preview screen is based on this default stitching parameter. However, the stitching effect may vary due to
differences between specific shooting scenes. If the stitching effect doesn't meet the requirement, users can use calibrate
the stitching effect on the camera or control app.
Please note that the calibrate stitching only takes effect in the following situations: