28
TROUBLE SHOOTING
1. Change the battery
.To change the computer battery ,please slide the computer
from the computer holder ,remove the battery cover on the back of the computer
console,and remove the batteries.Replace with 2Xaa batteries.Finally put the cover
back on the console,and slide the computer back on the computer holder.
2. Computer not working correctly
. If your computer is not working correctly,please
check whether the lower sensor wire is connected to the upper sensor wire,and
make sure the upper sensor wire is plugged into the computer,When you have
checked the above,and the computer still not working,then please make sure the
batteries are installed correctly in the computer and the batteries are still working.
3. No resistance
. If there is no tension resistance on the bike,please make sure the
upper tension cable is connected to the lower tension cable.Turn the tension knob
abti-clockwise to it’s lowest level.then go to the tension starp buckle which is
situated on top of the flywheel cover at the base of the front post. Loosen the
tension strap.pull it through the buckle until you can feel some resistance on the
strap then lock it back around the buckle.now mount the cycle and turn the
pedals,the tension control knob can now be used for a finer adjustment ,if you find
it is now too tight to back to the tension strap buckle and loosen the strap slightly.
MAINTENANCE
1.
Before using the bike, always make sure all bolts/nuts are fully tightened
2.
A spent battery is hazardous waste, please dispose of it correctly, and do not
throw it in the trash.
3.
When eventually you want to scrap the machine, you should remove the
batteries from the computer, and dispose separately as hazardous waste.
EXERCISE MONITOR INSTRUCION MANUAL
SPECIFICAFION:
TIME(TMR)………....00:00-99:598MIN SEX………………..MAN/WOMAN
SPEED(SPD)…………....0.0-99.9KM/H AGE………….……………10-99YO
DISTANCE(DST)…….....0.00-999.9km HEIGHT……………….110-200CM
CALORIES(CAL ).…..0.00-999.9KCAL WEIGHT………….……10-200KGS
PULSE……………………..60-220BPM
KEY GUIDE
MODE:
1.select function to be preset to enter setting mode in the following order:
Gender-Height-Weight-Age-Time-Distance-Calorie-Pulse
2.Hold two seconds to reset all of the values to zero.
3.Hold over 5 seconds, display and function will return to preset your personal data
for body fat measuring.
RECOVERY(If have)
: Press this button going into pulse recovery detecting.
MEASURE:
Press this button going in to measure your body fat detecting. Before operating
this function you have to enter your personal data in monitor.
