Assembly Instructions
A s s e m b l y S t e p 2
A.) Cover Assembly
Slide the
Left Cover (#15L)
and
Right Cover (#15R)
onto
the left and right of the
Hand Rail (#13R/L)
.
B.) Adjustable Pivot Bar Assembly
Each
Adjustable Pivot Bar (#06)
has three adjust able holes in it.
These three holes are designed to be a fine -tune adjustment that
will allow you to shift your center of gravity,
so that you can easily control the rate of inversion. Insert each of
the two
Adjustable Pivot Bars (#06)
into the slots located on the
Back Rest Frame (#07B)
ensuring that they both line up to the top
holes. Proceed with these instructions for now and if you are not
satisfied with the amount of control you have during the inversion
process, please return to this step and move the
Adjustable Pivot
Bars (#06)
down to the
second hole or to the lowest hole and try again.
A
NOTE: EACH HANDLE BAR SHOULD BE PROPERLY
SEATED INSIDE EACH BRACKET. A BRACKET PIN
SHOULD ENGAGE THE HOLE OF EACH HANDLE BAR.
BOTH HANDLE BARS SHOULD ALWAYS BE SET TO
THE SAME POSITION.
Insert a
Bolt (#47)
and a
Washer (#33)
through the bottom of both
Adjustable Pivot Bars (#06)
and secure it with a
Washer (#33)
and
a
Lock Nut (#30)
. Insert a
Lock Pin (#49)
on the top of both the
Adjustable Pivot Bars (#06)
. This is for an additional safety
measure.
C.) Back Rest Frame Assembly
Open the
Safety Hooks (#37)
on the brackets located on the A-
FRAME. With the help of an assistant, lift the
Back
Rest Frame (#07B)
and align the
Adjustable Pivot Bars (#06)
B
into the two slots. Make sure both sides are properly seated into each
slots. Do not be alarm if the frame does not fit perfectly in the slot.
Have your assistant pry apart the handle bars to align it for a perfect
fit. Test the
Back Rest Frame (#07B)
by rocking it back and forth a
few times. After you have ensured that the
Back Rest Frame (#07B)
rotates smoothly, lower the
Safety Hooks (#37)
over the
Adjustable
Pivot
Bars (#06)
as far as they will go. Once the
Safety Hooks (#37)
are
secure, insert
Hex Bolts (#50)
into the
Pivot Brackets (#40)
to lock
the
Safety Hooks (#37)
in place.
C