Insportline 5547 Sprynkl, User Manual, Page: 24 / 27

PULSE After you hold two hands to the handgrip sensors, the monitor will display your current
heart rate figures. You may set target figure before training. Once your heart rate is
exceed to the target, the monitor will alarm to remind you.
TEMPERATURE
Displays current room temperature from 0
℃
to 60
℃
.
O
PERATION
1. Installs 2 pieces of 1.5V #3 batteries, then the screen will display as following “Drawing A” and have
“Bi” sound at the same time.
Drawing 1 Drawing 2
2. Get access to the set-up mode of TIME/DISTANCE/CALORIES. When you are in each set-up mode.
For instance the time set-up, when the time value is blinking, you can press "SET" button to adjust the
number. Press "Mode" button for confirmation and skip to next set-up. The set-up of DISTANCE &
CALORIES is the same as TIME set-up.
3. When you are in PULSE mode, you may press SET button to set target. After setting, press "MODE"
button to confirm and skip to TIME screen. Continuously press "MODE" button will act this circle. If
you do not enter the RPM and PULSE signal or manual set-up time over 4 minutes in this mode, it will
be skip to SLEEP mode shown as "Drawing B".
4. After the exercise starts and setting up the TIME, DISTANCE, CALORIES. In SCAN mode shown as
"Drawing C". SPEED/TM/DIST/CAL/PULSE will skip to display every 6 seconds. The order is as
below "Drawing C"
5. You can also press "Mode" button to select single function display.
Drawing 3
6. When there is any function has been preset the target (TIME or DISTANCE or CALORIES), the
function will be counting down from the preset to zero while the training starts. Once the target is
achieved to zero, the monitor start to beep for 8 seconds, and the function will be counting up from zero
directly if the training is going.
7.
RECOVERY
(1) When press "RECOVERY" button, the RECOVERY function will work. At this time only PULSE
and TIME is working, other function will not be displayed, and the Sensor Input is not available. TIME