Page 21
Step 23: Attach the Molded Top Cap to the Main Frame using: 2 - M10 x 25 Button Head Bolts
1 - M8 x 12 Button head Bolts
Note : Tighten bolts, but do not over tighten. 2 - M10 Large OD Flat Washers
1 - M8 Flat washer
Align the four tabs on the bottom of the Rubber Cups with the four notches in the bottom of the
pockets in the Molded Top Cap and insert the Rubber Cups into the pockets.
Insert the Rubber Tablet Holder into the Pocket in the Molded Top Cap. The Rubber Tablet Holder
only fits one way. Make sure the outer edge of the Rubber Tablet Holder sits flat against the
Molded Top Cap.
1 - M8 x 12 Button Head Bolt
1 - M8 Flat Washer
2 - M10 x 25 Button Head Bolts
2 - M10 Large OD Flat Washers
Step 23
Rubber tablet holder only fits one
way. Make sure the outer edge
of the tablet holder sits flat
against the molded cap.
Align the four tabs on the
bottom of the rubber cup
with the notches in the
bottom of the pocket.
Rubber Tablet Holder
Rubber Cup
Rubber Cup
Molded Top Cap