Page 10
Step 8: Insert two Guide Rods into the holes in the bottom tube of the Main Frame. Carefully tilt the
Guide Rods back away from the machine. Slide one Rubber Donut into each Guide Rod. Slide ten
Weight Plates onto the Guide Rods. Make sure the recessed area on the front of the weight plate
is facing towards the front of the machine. Slide Top Weight assembly onto the Guide Rods.
Slide the Top Weight Stop Assembly onto the Guide Rods making sure the rubber pad is facing
down. Attach the Upper Pulley Mount, Top Weight Stop Assembly, and Guide Rods to the Main
Frame Using:
1 - M10 x 75 Hex Bolt
2 - M10 x 90 Hex Bolts
6 - M10 Flat Washers
3 - M10 Locknuts
1 - M8 x 20 Hex Bolt
1 - M8 Flat Washer
NOTE: Finger Tighten Only.
Rubber Donut
Step 8
1 - M8 x 20 Hex Bolt
1 - M10 x 75 Hex Bolt
2 - M10 x 90 Hex Bolts
6 - M10 Flat Washers
3 - M10 Locknuts
Guide Rods
Upper Pulley Mount, Left
Front of weight plate has recessed
area for the number sticker
Bottom of weight
plate has three feet
Top Weight
Top Weight
Stop Assembly
Main Frame