LinkPower
LPS1000 Adjustable Voltage PoE Switch
Page 49 of 71
3.3.2 View
The “View” command displays the following LPS1000 System Information: Firmware Version,
MAC Address, IP Address, Subnet Mask, Default Gateway, Board Temperature, Heartbeat
Count, and Port 1 Through Port 5 Name and Voltage.
3.3.3 Write
The “Write” command saves the current configuration. It is Important to Issue the Write
command before exiting the USB management console to retain the most current changes to
the LPS1000 configuration.
3.3.4 Portrst
The “Portrst” command power cycles one of five LPS1000 PoE port. Performing a port restart
while a PoE port Is off will not do anything.
3.3.5 Default
The “Default” command restores the LPS1000 factory default configuration values. See
Appendix for the factory default configuration values.
3.3.6 Net
The “Net” command configures the LPS1000 IP address, subnet mask, and default gateway.
These values need to match the subnet it resides in to ensure proper remote access capability.
Please consult a network administrator for recommendation on this setting if you are unsure of
the values.
3.3.7 User
The “User” command changes the user name and password of the LPS1000. The user name
and password is not updateable over HTTP. Please securely note down your user name and
password for your own reference. Forgetting these very important information will require
local access to the LPS1000 to perform hardware factory default.
3.3.8 Quit
The “Quit” command will log out the user from the USB management console. To log back
into the LPS1000 will require the user name and password.