NVC210
User’s Guide
Rev.1.2 (Aug. 2009)
13
13
13
13 of 56
of 56
of 56
of 56
collision of the power through the standard PoE and AC adaptor.
2.
Install “IP installer” and “NVR100 or NVM1000” on your PC.
Detailed information for installing these programs can be found in
[IP-Installer User’s
Guide]
and
[NVR100 or NVM1000 User’s Guide]
,
respectively.
3.
Assign IP address to NVC210 using IP installer.
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in
[IP-Installer User’s Guide]
.
If network type is
xDSL or Cable modem you need supplementary information provided by your ISP.
4.
Connect to NVC210 in Administrator Mode for initial parameter set-up.
All parameters are set to factory default state when NVC210 is delivered. You are asked to
configure the system for your environment in administration mode. Detailed information of
using administration mode can be found in
[
5.
Configuring NVC210 in Administrative
Mode]
. Among the parameters, the parameters in the following table should be set-up with
proper values. Detailed information for the parameters in Administrator Mode is found in
[
5.
Configuring NVC210 in Administrative Mode]
[Note]: Set-up values are preserved even the power is turned off.
Page
Parameter
Setup value
Factory default value
Video Size
Set the resolution of the video
transmitted from NVC210.
Max Upload Rate
Set this value smaller than the upload
speed of your network.
Frame Rate
The
number
of
frames
to
be
transmitted per second.
Basic Setup
Video Rate
Bandwidth
assigned
for
video
transmitted from NVC210.
Make sure that you press Check
button to find out the number of
maximum possible simultaneous
users then set the number of
users smaller than or equal to the
number.
User Admin
& Time
Setup
Administrator
name &
password
For safety, you are recommended to
change these values from factory
default. For new connection, you need
to
input
changed
values
for
corresponding fields. Do not disclose
these values to others and memorize
these values.
Default value
Username : root
Password : root
