— 35 —
Shown above is an entire FM-band plot of the busy Los Angeles
FM market. Three
Scan Type:
modes may be selected at the bot-
tom of the screen. The 551 can scan the band and display only
the
RSSI
level; this is the quickest scan. It can also scan and
display both the
RSSI + RDS
information, which takes a bit
longer, and it can scan and display
RSSI + RDS + HD
infor-
mation, as in the example, which requires a double-scan of the
band.
Start Scanning
To start a band scan, click the
Scan
bar at the bottom of the
page.
Step Size:
defaults to 200kHz; 100kHz steps are also
available.
In the example scan above, every FM carrier found is represent-
ed by a vertical bar. Bar height indicating signal strength in
dBµV per the annotation along the left side. This was an
RSSI +
RDS + HD
scan; had it been done in the simple
RSSI
mode, all
stations would show up as yellow bars.
Bars and Dots
‘Hovering’ over (not clicking on!) a yellow bar
shows the
Freq:
and
RSSI:
numerical level in a
pop-up, as in this inset image at the right.
A yellow bar with a red dot indicates that the
station carries RDS information. (The red dot
appears only when
Scan Type:
is set to
RSSI +
RDS
or
RSSI + RDS + HD
.)
Summary of Contents for Dante 551
Page 1: ...551 Modulation Monitor Installation User Guide www inovonicsbroadcast com ...
Page 2: ......
Page 62: ... 58 ...
Page 64: ......