Chapter 3 System Commissioning
- 42 -
3.3.4 Elevator Calls
Mode
Display of the Floor Selector
Mode 1: Enter the destination floor directly.
Note: The interval between two keys are pressed
must be smaller than the input delay time specified
by F1-00 (Key pressing interval for non-disabled
people). If no key is pressed within the interval
specified by F1-00 (Key pressing interval for non-
disabled people), the earlier input is regarded as the
destination floor.
1
2
3
4
5
6
7
8
9
★
0
—
5
Mode 2: If a large number of passengers need to take
an elevator at the same time, enter the destination
floor numbers,
and the number of passengers
successively. That is, enter the
"
destination floor
n + the number of passengers
"
.
Note:
must be pre-set as the grouping key.
1
2
3
4
5
6
7
8
9
★
0 —
5
☆
3
Operation result 1: After a passenger enters a valid
floor number, the floor selector displays the ID
and direction of an assigned elevator for a period
specified in F1-02 (ID display time of an assigned
elevator). As shown in the figure on the right, the
system assigns elevator A and the elevator A is on the
left side.
1
2
3
4
5
6
7
8
9
★
0
—
A
Operation result 2: If a passenger enters an invalid
floor number, the floor selector prompts
"
Please
select another floor
"
.
Note: An invalid floor may be the current floor or a
non-service floor of the GCB.
1
2
3
4
5
6
7
8
9
★
0
—
请重新输入
Example 1:
A passenger needs to take an elevator to floor 5 and presses 5 on the floor
selector. Then,
"
C>>
"
is displayed on the screen to instruct the passenger to wait for
elevator C on the right side, as shown in the following figure.
Please select
another floor.
