InoTec SCAMAX H12, User Manual

Page: 121 / 136

Disruptions User Manual H12 / SCAMAX® 8x1 - Version 2019.12
Page 121 of 136
9.2.2. (2nd) Output Hopper Open
(Error 201/202)
These errors are displayed when the Output Hopper
was opened during scanning or the 2nd Output Hopper
was not properly closed at Scanstart. To eliminate the
error, the Output Hoppers must be properly closed ( see
chapter 6.2. ). Before anew Scanstart, all documents that
may still be in the transport passage must be removed,
since otherwise subsequent errors occur.
9.2.3. Roller Assembly Incorrectly Installed
(Error 203)
This error is displayed when on the device during the
scanning process, the Roller Assembly has jumped from
its holder or an attempt was made to start a scan process
while the Roller Assembly was not installes correctly. To
fix the error, it must be checked if the Roller Assembly
sits correctly in its holder ( see chapter 7.2.1. ). Before anew
Scanstart, all documents that may still be in the transport
passage must be removed, since otherwise subsequent
errors occur.
9.2.4. (2nd) HS Stacker Arm in Wrong Position
(Error 204/205)
These errors are displayed when a scan process was
started and the corresponding HighSpeed Stacker Arm
was not in the position to operate the current output
mode ( see chapter 5.7.3. ), or it was folded from the
required position during operation. To eliminate the
respective error, the respective HighSpeed Stacker Arm
must be folded in the required position. Before anew
Scanstart, all documents that may still be in the transport
passage must be removed, since otherwise subsequent errors occur.
9.2.5. Cartridge Imprinter Front/Back Undetected
(Error 206/207)
These errors are displayed only when the loaded scanner
setting provides for use of the respective imprinter and
its ink cartridge is not available at Scanstart. In order to
eliminate the respective error, the right seat of the res-
pective ink cartridge must be tested ( see chapter 8.3.1. ),
before the scanning process can be started again.
9.2.6. (2nd) Output Tray Full
(Error 208/209)
These errors are displayed when the Output tray of the
Output Hopper or the 2nd Output Hopper has reached
its maximum tray height ( see chapter 5.7. ). To eliminate
the respective error,the documents must be removed
from the concerning Output Tray before scan process
can be started again.