Cleaning and Maintenance
User Manual H12 / SCAMAX® 8x1 - Version 2019.12
7.2.
Cleaning/Maintenance of the Paper Input
With an increasing number of processed documents, some parts in the scanner get dirty or worn out,
and must be cleaned or replaced. This includes in particular the friction linings of the Input Rollers and
the Separation Roller. This can be easily carried out by each operator that adheres to these instructions.
Since excessive dirt or wear of the Paper Input always result in increased level of feeder or double feed
errors, the cleaning and maintenance involved is a demand-oriented activity by which the cycle is
significantly influenced by the kind of documents to be processed.
7.2.1.
Cleaning the Feeder Roller Friction Linings-
For the cleaning or replacement (
next chapter
) of the
Feeder Roller Friction Linings, it is necessary to remove
the Roller Assembly. For this, a unlocking for the holder
is attached on the left next to the Roller Assembly. To
dismantle the unlocking pin is pushed to the left and
held in this position while the Roller Assembly is swung
out to the right.
To remove the Input Rollers, the Assembly is taken in
hand with the rollers upwards and the two locking hooks
forward. Now press both hooks in succession forward
while gently pressed from below with the finger against
the Input Roller so that the Housing Roller Assembly can
be unfolded.
CAUTION
To clean the linings, exclusively use the intended SCAMAX® SV1A Cleaning Solution for Rubbers
& Belts. The use of other solvents such as benzene, acetone, or the like can cause damage to
the linings.
Since SCAMAX® SV1A Cleaning Solution for Rubbers & Belts contains solvent, the contact with
sensitive surfaces must be avoided, as these might otherwise be damaged.
WARNING
SCAMAX® Cleaning Solution for Rubbers & Belts is flammable and removes fat. Keep smoking
and naked flames away. For sensitive skin protective gloves should be worn. These are con-
tained in two different sizes in the cleaning kit. The warning labels on the containers of the
cleaning fluid must be observed!
Notice
It is recommended to put the roller linings
at the earliest
10 minutes after cleaning in opera-
tion, otherwise solvent residues of the used Cleaning Solution for Rubbers & Belts still adheres
on the linings. An application in "wet" state leads to more rapid dirt accumulation of the linings
due to increased ablation of ink- and toner residues and dust.
