Disruptions
User Manual H12 / SCAMAX® 8x1 - Version 2019.12
9.1.2.
(2nd) Output Hopper Open
(Warning 101/102)
These warnings appear initially only in the status area,
meaning that the Output Hopper or the 2nd Output
Hopper is not closed properly. To eliminate the respec-
tive warning, the Output Hoppers must be properly clo-
sed
(see chapter
). Trying to start a scan process in this
state, leads to a similar error message
(see chapter
9.1.3.
Roller Assembly Incorrectly Installed
(Warning 103)
This warning appears initially only in the status area and
means that the Roller Assembly was not installed correc-
tly. To eliminate the warning it must be proved whether
the Roller Assembly is properly seated in its holder
(see
chapter
). Trying to start a scan process in this state,
leads to a similar error message (
see chapter
9.1.4.
(2nd) HS Stacker Arm in Wrong Position
(Warning 104/105)
These warnings appear initially only in the status area,
meaning that the concerned HighSpeed Stacker Arm is
not in the position required to operate the current out-
put mode
(see chapter
). To eliminate the respective
warning the concerned HighSpeed Stacker Arm must
be folded in the required position. Trying to start a scan
process in this state, leads to a similar error message
(see
chapter
9.1.5.
Cartridge Imprinter Front/Back Undetected
(Warning 106/107)
These warnings are displayed only when a print text
has been defined for the Imprinter Front or Back, in the
current scan profile and its ink cartridge is not available.
In order to eliminate the warning, the right seat of the
respective ink cartridge must be tested (
see chapter
). Trying to start a scan process in this state, leads
to a similar error message
(see chapter
).
9.1.6.
Calibration in Progress
(Warning 108)
This warning means that the scanner is currently in a
calibration process. In this state, the device may not be
opened or turned off. The warning disappears as soon
as the calibration is complete. If the calibration failed, an
error message appears (
see chapter
