iNO EURO MINI, Operating Instructions Manual

Page: 17 / 36

17
Unload the machine with special care to avoid any damage.
Check that all nuts and bolts are fixed and tightened. Specially check
the bolts and nuts for the working blades.
5.2. Attachment and detachment from the tractor
Before any operation check:

That the machine is in good condition,

That all guards are on proper places and in good condition,

That working blades are complete and undamaged,

That all greasing points are greased well and that in gearbox
is oil enough,

Appropriate tensioned belts ,

That rpm and direction of rotation on the drive axle
correspond to those on the machine.
To attack the machine to the tractor, bring the tractor lower lines near
the machine, to the points corresponding to the pins. Insert the pins and
secure them with the spring clips. Fit the top link, raise the machine to a
perpendicular position with the ground. Adjust the two tractor lower
linkage stabilizers thus fixing the machine to the tractor in a central
position. Connect the hydraulic cylinders and check if it works.
3-point hitch of the machine must be in a simetrical
position with the tractor.
Top linkage point has two working modes: front linkage and rear
linkage. After changing the position put back the security pivot pin
(Fig.7/2). Security pivot pin must always be on its position during
transport. For floating position move away this pin during work
(Pos.7/1).
Always check that rpm and direction of rotation on tractor and
flail mower are the same.