8
INNOWATER PHRH
4. PH CONFIGURATION AND CALIBRATION
To access the Configuration Menu, press the OK key from the main screen and
scroll with the help of the arrows.
4.1 Enable/disable pH function
You can enable or disable pH function in menu
1. pH Config.
Push OK to get into pH configuration sub
-
menu and use arrows to scroll through
the options:
To access the pH Activation Menu, press the
OK
key
.
Use arrows
Λ
o
V
to choose and press
OK
4.2 Setpoint configuration
Enter with the
OK
key. It will show the following screen:
The calculation of the dosage is made by establishing the two set points, A and B,
and the relative volume of dosage that is required in each of these points.
-
When the pH is below the lower set point, the pump will not dose acid.
-
When the pH is between both points, the chlorinator will send a proportional
signal defined by both points. For example, in the case of the figure, if the pH is at
8 the pump will dose at 40%.
MAIN MENU
1 pH config
PH config
1 pH activation
PH function
ACTIVATED
OK
Configuration PH
2 Setpoints
A: pH 7.0 10%
B: pH 9.0 90%
