Innovative NV9, Operation Manual

Page: 21 / 41

NV9 Operations Manual 21
e
IS option of the interface firmware must be loaded into the NV9.
dators IRQ
POWER SUPPLY.
THE NV9 GROUND MUST BE CONNECTED TO THE GROUND OF THE
46-PS), or contact support@innovative-
technology.co.uk.
6.9 NON-ISOLATED SERIAL PROTOCOL (NIS)
To use NIS mode DIPswitches 3 and 4 must be in the Up position to select ‘Special’ mod
on the validator and the N
(DIPswitch 2 is not functional in this mode).
There is a single output DATA line from the NV9. There are three control lines, two from
the controller ‘’ACCEPT ENABLE’’ and ‘’SEND’’ and one from the Vali
(INTERRUPT) (see table 10).
CAUTIONS:
PLEASE NOTE THAT THE NV9 IS REQUIRED TO OPERATE ON A +12VOLT
DC
CONTROL SYSTEM.
For further details on this protocol please refer to the series 2000 interface manual
(reference number 20105-0028500
Connection Details:
Signal NV9
+12V 15
0V 16
ACCEPT ENABLE
6
SEND 7
IRQ (INTERRUPT)
2
DATA 1
OUT_OF_SERVICE 3
Table 10 - Extended Interface USA Serial
ENCY AND FIRMWARE FILES
d with an updated Currency
nd later (March 2007)
OTE VALIDATOR CURRENCY MANAGER
order to use the ITL Bank Note Validator Currency Manager software, which is supplied
ith a range of currencies, it must be inst
om the web site. For the PC Sys
A list of currently supported cur es is ere new releases
can be downloaded. Further details are available from support@Innovative-
technology.co.uk
7 UPDATING CURR
Note: Validators are supplied already programmed from the factory Please skip this
section unless the validators need to be re-programme
irmware file. F
The NV9 Validator can only be re-programmed using the ITL Bank Note Validator Currency
Manager 3.2.0 or greater or via a DA3.
Note: Cloning is not available for the NV9 with firmware 3.20 a
7.1 ITL BANK N
In
w alled from the DA1/DA2 CD or by downloading
fr tem Specification refer To Appendix F.
renci ntained on our web site, wh mai
Copyright Innovative Technology Ltd 2008 GA326-6