NV10 Operations Manual – GA333-3
8 of 38
© Copyright Innovative Technology Limited 2005
5: NV10 User Interface
The user interface with the NV10 is shown below (see figure 2). It is simply a red and green LED and
a set of four DIPswitches. The LED’s indicate the operational status of the NV10, while the
DIPswitches set the basic operating mode of the unit.
Figure 2 – NV10 User Display and DIPswitches
5.1:DIPswitch Settings.
The four DIPswitches can be set to a combination of either up or down depending on the
configuration required for the particular NV10.
Switch 1 – Spare
Switch 1 currently has no function and is reserved for future use.
Switch 2 – pulse multiplier
This switch is used to modify the behaviour of the selected machine interface. Details of the function
of this switch are covered in the interfaces’ description in this manual.
Currently the only interface to make use of this switch is the pulse mode. In this mode the switch can
be used to multiply the number of pulses given by a factor of four. When the switch is down the
multiplier is 1, when the switch is up the multiplier is 4.
Switches 3 and 4 – Machine Interface protocol selection
These switches are used to select the machine interface to be used. The NV10 supports four
interfaces, as shown below, (see table 1).
Special
STATUS
1 2 3 4
O
N
GREEN
RED
1 2 3 4
Interfaces
Pulse
S.S.P
.
4
3
2
1
Parallel
AMBER
Pulse
Multiplier
