NV10 Operations Manual – GA333-3
27 of 38
© Copyright Innovative Technology Limited 2005
10
.
2: Belt Changing
•
With the NV10 note paths exposed (see figure 10) place the unit on a clean dry surface.
•
Remove the lower cover plate by lifting up the retention catch and carefully sliding it back
(see figure 11).
•
Push the 2 belt tension springs inwards then slide each belt off the drive unit body,
smallest wheels first.
•
Replace the belts by fitting them over the drive unit body legs, smallest wheels first.
•
Place the lower cover plate into the locating slots (2 each side) pushing forward and down,
the plate will ‘’click’’ confirming correct insertion.
•
Connect the upper and lower note path back together.
Figure 11 – NV10 Belt Access
Belts
Lower Cover Plate
Belt Tension Springs
Retention
Catch
Drive Unit
Body
Locating
Slots
