INNOVASUB Monitoring Development Board, User Manual

Page: 4 / 29

4
Table of Figures
Figure 1
– Board Overview......................................................................................................... 7
Figure 2
– MSP-TS430PN80USB Target Board ......................................................................... 9
Figure 3
– LCD Display .............................................................................................................10
Figure 4
– Extension Pins .........................................................................................................11
Figure 5
– Battery .....................................................................................................................12
Figure 6
– Mini-USB Connector for Charging the Battery ..........................................................12
Figure 7
– Control Pins (on the Left) .........................................................................................13
Figure 8
– SW1 and SW2 .........................................................................................................14
Figure 9
– SW3 and L2 .............................................................................................................15
Figure 10
– Jumper JP9 in Position SNS1 and Jumper JP10 in Position SNS2 ........................16
Figure 11
– XBEE1 (RN-171XV) and XBEE2 (RN-42XV) ..........................................................16
Figure 12
– SENSOR2, SENSOR1 and Micro-SD Slot .............................................................17
Figure 13
– Underwater Wireless Module Connector ................................................................17
Figure 14
– Two INNOVASUB Pressure Sensors and Two T-Pipes ..........................................18
Figure 15
–INNOVASUB Pressure Sensors with USB Cable for Connection with UEPM
Development Board ..................................................................................................................19
Figure 16
– PIEZO1 and PIEZO2 Piezo-Switches .....................................................................19
Figure 17
– POT1 and POT2 Potentiometers ............................................................................20
Figure 18
– LED1, LED2, LED3 and LED4 ................................................................................21
Figure 19
– X4 (Jack 3.5mm) and JP15 (0.1”) Connectors for Oxygen Sensor .........................21
Figure 20
– ADC Module – JP16 Connector for 6 x 12-bit ADC Inputs ......................................22
Figure 21
– SENSOR3 ..............................................................................................................23