13
CAUTION!
Lithium batteries are explosive and can easily fire. The battery may explode or fire if
mistreated. Do not disassemble or dispose on fire. Do not charge out of charging
conditions. Do not heat above 100°C (217°F) or short circuit. Do not crush or modify.
CAUTION!
The Mini-USB connector used for charging the battery is not USB compliant. Do not
connect anything else than the power supply to that connector. Connecting a USB
device to that port may damage it, cause explosion or fire.
CAUTION!
Use a power supply of regulated 5V and at least 1000mA capacity. The use of an
inappropriate power supply may cause explosion, fire or the damage of the power
supply and / or the battery.
CAUTION!
Do not charge the battery out of the 5°C – 45°C (41°F – 113°F) temperature range.
4.5. Control Pins
The control pins can be used to control the voltage on the board and to control the
current flowing through the battery.
The pin GND1 (JP6) is a reference for the ground level on the UEPM Development
Board.
The connector JP5 is connected in series with the battery in order to control the current
flowing through it, with the help of an amperemeter. If not in use, place a jumper on JP5.
Figure 7
– Control Pins (on the Left)
