InnoMedia MTA8000 Series Administrative Guide
Page 34
Copyright © 2022 InnoMedia. All rights reserved.
Feature Setting
Emergency
Number
If the entered number is dialed, all call
features are disabled. (Call Waiting, Call
Transfer, etc…)
Allow BYE at End of
Emergency Call.
If enabled, when you hang up a call to an
emergency number, treat this as a normal
call hang-up. If it is disabled, the MTA will
ring the phone when you hang up instead of
terminating the call.
Enable Caller ID of
Emergency Call
If Caller ID is enabled, on an outbound call to
the Emergency Number, Caller ID will be
sent.
Service Code
The following settings are applicable to
device based call features.
Cancel Call Waiting
The service code to cancel/resume receiving
and answering an incoming call when this
line is engaged on a call.
Call Transfer
The service code to transfer the current call
to another destination.
Caller ID Display
The service code to display the incoming
caller phone number and its display name.
Caller ID Block
The service code to hide the outbound caller
phone number and its display name.
Do Not Disturb ON
The service code for
“Do Not Disturb
-
On”
,
prevents incoming calls from ringing the
phone.
Do Not Disturb OFF The service code for
“Do Not Disturb
-
Off”
,
allows incoming calls to ring the phone.
Play My IP Address
When a phone is connected to the MTA, and
this service code is dialed, the current MTA
IP address will be played out to the phone
handset.
Speed Dialing
Enter a prefix to use with the Speed Dialing
Settings under the Port Config section. For
example, if you configure a #9 in this setting,
to dial the phone number for Speed Dialing
Settings 0, simply dial a #90. Ensure the
Prefix and Speed Dialing Settings don't cause
a dialing conflict with other features such as
Call Transfer and Caller ID Display.