Chapter 4: Configuration
41
IP Address:
specify if the Gateway can get an IP address from the service provider automatically or not.
Please click Obtain an IP address automatically via DHCP client to enable the DHCP client function or click
Specify an IP address to disable the DHCP client function, and specify the IP address manually.
Authentication Protocol:
Default is Chap (Auto). Your ISP will advise you whether to use Chap or Pap
.
Connection:
Always on:
A PPPoE session will be established upon device power on and the connection will
remain live or connected.
Connect on Demand:
If you want to establish a PPPoE session only when there is a packet
requesting access to the Internet (i.e. when a program on your computer attempts to access the
Internet).
Idle Timeout:
Auto-disconnect the broadband firewall gateway when there is no activity on the line for a
predetermined period of time.
Detail:
You can define the destination port and packet type (TCP/UDP) without checking by timer. It
allows you to set which outgoing traffic will not trigger and reset the idle timer.
RIP:
RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.
MTU:
Maximum Transmission Unit. The size of the largest datagram (excluding media-specific headers)
that IP will attempt to send through the interface.
TCP MSS Clamp:
This option helps to discover the optimal MTU size automatically. Default is enabled.
MAC Address Spoofing:
Some service providers require this option. You must fill in the MAC address that
is specified by your service provider. Default is disabled.
Summary of Contents for 8860-C1
