Innoband 8860-C1, User Manual

Page: 11 / 128

Chapter 2: Installing the Gateway 10
Ethernet Port # 4 can be used as a console port. You need a special console
converter that is included in the package to connect the LAN 4 console with
your computers’ RJ-232 port (9-pin serial).
The Back Panel
Port Meaning
1
DSL
Connect the supplied RJ-11 ADSL cable to this port.
2
Ethernet 1 — 4
Connect an Ethernet cable (Cat-5 or Cat-5e) to one of the four LAN
ports when connecting to a PC or an office/home network of 10Mbps
or 100Mbps.
Caution : Port 4 can either be a LAN or a Console port but can not be both
at the same time.
3 RESET
To be sure the device is being turned on press RESET button for:
1-3 seconds : quick reset the device.
6 seconds above, and power off, power on the device : restore to
factory default settings. (Cannot login to the gateway or forgot your
Username/Password. Press the button for more than 6 seconds).
Caution : After pressing the RESET button for more than 6 seconds, be
sure to power cycle (turn off and then on) the device again.
4
Power
Connect the supplied power adapter to this jack.
5
Power Switch
Power ON/OFF the gateway
2
5
1
3
4