INNO INNOPAD, Instruction Manual, Page: 24 / 28

24 | INSTRUCTION MANUAL INNO
PAD
INNO
6.1.2 INSTALLING THE INSTALLATION BOX
1. Remove the transport lock then take the installation box
out of its packaging.
2. Hold the installation box to the flush-mounting box, taking
care that the „TOP“ marking at the bottom of the box is
facing up, and break out the cable feedthrough.
3. Ensure that all live cables are disconnected from the po-
wer supply at the installation site!
Feed the power cable
and, if necessary, audio wire through the opening into the
installation box. Take care not to damage the cables.
4. Secure the power cable to the rear of the installation box
with the tension relief (Fig. 4).
Tip: The tension relief can be adjusted for various cable
diameters by rotating the tension relief lever.
5. All electrical installations must be carried out by a quali-
fied electrician.
Cut the power cable to a length of
250 mm from the tension relief and attach it to the pre-
assembled mains supply in compliance with the connection
regulations (Fig. 5).
6. All electrical installations must be carried out by a
qualified electrician.
Fix the audio wire to the audio output
on the main board to feed the audio signal out via cinch
cable (NF) (Fig. 5).
7. Insert the installation box in the flush-mounting box,
ensuring that the „TOP“ marking is facing up, and fix it with
the bolts.
8. Adjust the installation box perpendicularly with the help of
the movable inside of the flush-mounting box and fix it in
position by tightening the bolts (Fig. 6).
6.1.3 INSTALLING THE METAL BASE PLATE
1. Take the metal base plate out of the packaging.
2. Ensure that all live cables are disconnected from the po-
wer supply at the installation site! All electrical installa-
tions must be carried out by a qualified electrician.
To earth the metal base plate, connect the earth cable to the
earth connection on the rear of the metal base plate.
3. Fit the metal base plate correctly into the recesses in the
installation box and fix it with the medium-sized stop screw
to the corresponding holders (Fig. 7).
4. If you are using an iPad 2™*, insert the 2 spacer plates
in the bottom of the metal base plate for a perfect fit
underneath the decorative glass frame (Fig. 8).
5. Fix the metal base plate − including spacer plates when
installing iPad 2™* − to the installation box with the
remaining stop screws.
6.1 SOLID WALL INSTALLATION
*Trademark notice: iPad™ is a trademark of Apple Inc., registered in the U.S. and other countries.
Figure 4
Figure 5
Figure 6
Figure 8
Figure 7