8
Integriti
Integriti
Integriti
Integriti
Integriti
LCD Terminal Keypads User Manual.
Each time a key is pressed, a short “beep” will be
emitted to indicate that the key press was accepted.
(The Installer can disable the beeping if necessary)
If the Terminal emits a long “beep”, it means that the
key press was not accepted or is not allowed.
You may only press one key at a time but key press
sequences may be as fast as you like.
The functions of the 20 keys during User Operations are described below.
The DIGIT keys are used for entering your secret PIN code.
You have 10 seconds to enter each digit, and must press the
<OK> key when complete.
These keys can also be used to search for an item to be
controlled by selecting the first letter of it’s name.
The <OFF> and <ON> keys are used to turn Off or turn On,
the Area (or Area List) or Action named on the Display at the
time.
The <HELP> key can be pressed at any time to display a
“Help message” about the current operation being performed.
The <MENU> key is pressed after PIN code + <OK> if you
wish to perform any Menu operations. (Operations other than
Area On/Off, Door Access, etc.)
OR if pressed when not logged on, may allow Review of past
Alarms, System information and the Date & Time.
The <END> key is used when you have finished performing
the required operations or if you make a mistake while entering
your PIN code and want to start again.
The Keypad.
Operations & some programming can be performed by using the keypad on an LCD
Terminal. (Programming is normally performed via the Integriti Software)
