Place the primary tube (longer tube) into the wheel
well opening. Make sure the air mass sensor adapter
side is on the top side.
Press the tube with the air mass sensor side into the
2 7/8” X 3 1/4” step hose.
Line the primary intake bracket to the vibra mount
stud located on the shock tower mount.
Insert the factory air mass sensor in the the billet
adapter as shown.
The electrical harness clip is now pressed over the
mass air flow sensor. Press firmly until it snaps in
place.
Use one fender washer (X-6010) and one M6 nut (X-
6002) to secure the bracket to the vibra mount.
Reuse the two screws that secured the air mass sen-
sor to the factory air box.
Place two clamps (X-4004) over the 3” hose. Press
the 3” hose over the end of the primary intake.
use a 8mm nut driver to tighten the clamp over the
intake end.
Tighten the two screws securing the air mass sensor
the the billet adapter.
Use a 10mm 3/8 socket and ratchet to tighten the M6
nut to the vibra mount.
Figure 44
Figure 43
Figure 42
Figure 41
Figure 40
Figure 48
Figure 49
Figure 50
Figure 47
Figure 46
Figure
45
Figure 39
Proceed to screw the Vibra mount in place as shown
above
