Remove the battery cables from the battery post and
remove the battery the from the engine compartment.
Disconnect air box cleaner from the air intake duct
and lift the air box out of the engine compartment.
Depress end clips on the electrical harness clip and
pull the clip away from the mass air flow sensor.
Press the step hose over the throttle body and use two
power bands on the hose, tighten the band on the
throttle body side for now.
Loosen clamps that secures the air intake duct to the
throttle body (A) and the air box cleaner to the lower
air intake duct (B).
Loosen clamp that secures the air duct over the mass
air flow sensor. Disconnect and remove the mass air
flow sensor from the air duct as shown above.
The tabs with the holes are used to hook into the
notch located in the resonator box as shown above.
The head lamp is now pulled out of the frame and the
harness clip is disconnected from the rear of the head
lamp.
Remove top clips from lower air box (A) Once clips
have been removed, lift the top cover and remove the
inside panel filter. Loosen and remove the three bolts
on the lower air box fastened to the motor mount (B).
Once the air box has been removed, continue to
remove the air intake duct from the throttle body.
Remove the m6 bolt located on the corner battery
tray. Once you have removed the bolt, gently pry the
top resonator box loose.
Remove the two bolts from the tabs on the head
lamp. Once bolts have been removed, continue to
pull the head lamp out of the frame.
Page 2 of Part# SP1381
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
(A)
(A)
(A)
(B)
>>>
>>>
(A)
(B)
>>>
>>>
>>>
>>>
