The plastic plug is removed from the upper tab, then
the resonator is gently pulled out of the resonator
opening.
The vibra-mount is screwed into the pre-tapped brace
on the engine mount.
Screw the vibra-mount into the brace until it sits flush
over the engine mount.
The driver side bumper is pulled away and the res-
onator box is removed from the inside corner.
The air resonator box is now removed from the lower
corner.
The primary intake is now pressed into the step hose
located on the throttle body.
The primary intake is aligned for a perfect fit.
The straight hose is placed over the mass air flow sen-
sor. Two power bands are placed over the hose on the
mass air plow sensor and the power bands to the inside
of the mass air flow sensor are tightened.
The resonator elbow is pulled out and no longer
used for this installation.
Disconnect and remove the top plastic clips located
on the top bumper end. Peel the driver side bumper
bumper away and remove the air box cleaner.
The 13” vinyls trim is pressed over the resonator
opening s shown above.
The vacuum line is now placed over the intake port.
Page 3 of Part# SP1381
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20
Figure 21
Figure 22
Figure 23
Figure 24
Figure 25
>>>
>>>
>>>
>>>
>>>
>>>
