Inis Oirr MK2 Multifuel Boiler stove
6
removed. Next the upper centre plate can
be removed by pushing upwards at the
front of the plate and then lifting the
plate vertical and dropping down into the
firebox. Please see Fig below.
With the throat plate assembly now
removed a flexible flue brush can be used
to clean out the 3 flue-way baffles on
either side of the heat exchanger (See
below).
When the throat plate assembly is re
installed, cleaning of the fire box/grate
assembly can be done.
Firstly, lift away the front firebar (See
exploded view of stove for detail). Next
the grate side plates are removed by
moving the front end of the plate up.
Once it is lifted up, it can be
withdrawn. After withdrawal of both side
plates, lift each riddler bar on the left
side first and remove. With the riddler
bars removed, the rear firebox plate can
be removed by lifting up straight and
lifting away.
Sometimes, after extended use a flathead
screw driver may be needed to help lift
the plate free. At this point all the
vents and areas at the back of the
firebox can be cleaned out (never clean
the stove if it is still hot!!!).
Inspect all internal parts of the stove
and replace if needed. Only Inis Stoves
genuine parts should be used in the stove
To clean the paint of the stove we
recommend the use of a slightly damp
cloth with a mild detergent. Avoid using
abrasive material on the paint of the
stove.
If the stove is to be unused for a
prolonged period of time, for instance
over the summer months, the stove should
be fully cleaned and a lubricant applied
to all moving parts. The damper may be
left slightly open to facilitate a little
air movement through the stove and avoid
moisture build up. Avoid excess opening
of the damper as this will result in
