4. Installation of Air2-BS200
4. Installation of Air2-BS200
For optimal performance of the wireless system the transceiver module Air2-BS200 must be located at the
core of the wireless network and area of use of remote-control keys, in a placement which allows easy con-
nection of the I-BUS cable to the control panel.
All wireless protection devices should be located high up in order to increase their detection capabilities and
prevent inadvertent masking caused by large objects or building occupants.
"UUFOUJPO
Ferromagnetic materials which are located in the vicinity of the mounting position can
influence the magnetic field and can result in the reduced operating capacity of the
device.
It is possible to view on the keypads or via the programming and supervision software, the strength of the
wireless signal on each wireless device Air2-BS200; this data can be used to optimize the installation pro-
cess.
/PUF
A level 3 signal strength it is recommended for a good installation.
As an integral part of the system, the Air2 provides 3 inter-module transmission channels. This feature allows
you to select the channel in such way as to avoid over-the-air interference between two close-proximity wire-
less systems (for example, in two adjoining apartments).
8
Installation and programming manual- 100-DRAFT
