Ingersoll X12I, Quick Setup Manual, Page: 17 / 34

17
Primary Detected Pressure:
P00
1
102
98
80 psi
psi
psi
2
3
4
1
Active Table
Upper (Unload) Pressure Set Point
Lower (Load) Pressure Set Point
Minimum Pressure Alarm (Warning)
Differential Pressure:
P00
P2(SYS)
30 sec
1.0 bar
1
2
3
Alarm (Warning) Level
Alarm (Warning) Delay Time
Source of 2
nd
Pressure
Only show if the 2
nd
pressure sensor is activated in
air treatment pressure differential mode.
1
st
Remote Pressure:
P00
B01
1
Source of 1
st
Remote Pressure
Only show if pressure balancing function active.
Pressure Balance Function.
1.
2.
3.
4.
1.
2.
3.
1.
2
nd
Remote Pressure:
P00
B02
1
Source of 2 nd Remote Pressure
Only show if pressure balancing function active and
2
nd
remote pressure in use.
Pressure Balance Function
Sequence Rotation:
P00
#4 18:00
18 / 05 / 2006
A B C D
Day of the week (#4: Thursday), the time of day
(18:00) and the date (18/05/2006) of the next automated
sequence rotation event.
The active ‘mode’ of operation
“
AbCD
” The current active rotation sequence assignment.
Manual Sequence Rotation:
The sequence assignment can be manually rotated at any
time. When viewing the ‘Sequence Rotation’ information
screen press Enter:
The manual rotation symbols will appear and
flash. Press Enter again to execute a manual rotation or
Escape to abandon the manual rotation.
Automated sequence rotation is not disrupted by
a manual rotation; the next scheduled automated
sequence rotation event will still occur.
1.