Ingersoll-Rand TZ1050, User Manual

Page: 9 / 44

USER MANUAL
MODEL NO.: TZ730–1710
Rev. 08 – 14 September 2005
3
1.3.2 G
ENERAL
S
AFETY
T
IPS FOR
A
SSEMBLY
, I
NSPECTION AND
M
AINTENANCE
The purchaser is to ensure that all assembly, maintenance and inspection work is
carried out by personnel qualified to do it.
The personnel involved in assembly, operation, maintenance and inspection must have
the corresponding qualifications to do this work. Areas of responsibility and supervision
of the personnel must be clearly established by the purchaser. Should the personnel
not possess the necessary knowledge, then they must be instructed. If need be, this
training may be carried out by the manufacturer/supplier at the request of the purchaser.
Further, the purchaser is to ensure that all personnel completely understand the
contents of this manual.
Attention!

Never make structural changes to the adsorption dryer

Only use recommended spare parts as listed in section 5

Never weld on a pressure vessel or change it in any way

Carry out maintenance only when the adsorption dryer is OFF,
depressurized and disconnected from the electric power supply.
Danger!

Refer to the desiccant Material Safety Data Sheet (MSDS) when
installing or disposing of desiccant (see Appendix A)

Wear protective goggles when working with the desiccant

If desiccant comes into contact with the eyes, rinse eyes
immediately with a lot of clear water

If the desiccant is spilled, clean up without causing swirls of dust

In case of fire, there is no restriction on the use of fire extinguishing
material; the reaction with water and foam is defined as strong

A mask must be worn whenever handling desiccant.