EN
80446339 Rev E
EN-51
WEB ACCESS
NAVIGATION
Each of the main segments is represented by a tab on the top of web pages. Clicking on the tab will bring you to the screen for
that particular segment.
TAB NAVIGATION
The components of the tab navigation are as follows:
Home
Clicking this tab will bring the user to the HOME page. See section HOME PAGE
Event Log
Clicking this tab will bring the user to the EVENT LOG.
See section EVENT LOG UTILITY
Performance Log
(Xe-145 Only)
Clicking this tab will bring the user to the PERFORMANCE LOG.
See section PERFORMANCE LOG UTILITY
Graphing (Xe-145 Only)
Clicking this tab will bring the user to the GRAPHING page.
See section GRAPHING UTILITY
Maintenance
Clicking this tab will bring the user to the MAINTENANCE page.
See section MAINTENANCE UTILITY
Inspection Log
(Xe-145 Only)
Clicking this tab will bring the user to the INSPECTION LOG.
See section INSPECTION LOG UTILITY
Compressor Information
Clicking this tab will bring the user to the COMPRESSOR INFORMATION page.
See section COMPRESSOR INFORMATION
Account
Clicking this tab will bring the user to the ACCOUNT page.
See section ACCOUNT MANAGEMENT
COMMAND BUTTONS
All pages show five command buttons (Start, Stop, Reset Alarm, Load and Unload), five dash board icons and current status of
the compressor.
If the current user’s account type does not have the necessary access rights to control the compressor via the web
interface, remote control from the web interface will be disabled at the controller.
“Command Keys” on the web pages command the compressor to perform actions as specified in the following table.
Key
Name
Function
Start
Start the Compressor
Stop
Stops the compressor. This button should be pressed instead of the E-Stop for
normal stopping operation.
Reset Alarm
Clears Warnings and Trips once the condition is corrected.
Load
Loads the compressor. Not used with variable speed application.
Unload
Unloads the compressor. Not used with variable speed application.
Remote starting and stopping can be accomplished through the Ethernet Port. Panel power must be on, all utilities
must be running and permissive functions satisfied in order for the start-up from the web page.
There will be a 2nd Level of confirmation for each “Command Key “
RELEASED 01/Nov/2018 12:06:37 GMT
