Book 35393065 (7/02)
50
( )
SECTION 9 -- PARTS ORDERING
GENERAL
This publication, which contains an illustrated parts
breakdown, has been prepared as an aid in locating
those parts which may be required in the maintenance
of the unit. All of the compressor parts, listed in the
parts breakdown, are manufactured with the same
precision as the original equipment. For the greatest
protection always insist on genuine Ingersoll--Rand
Company parts for your compressor.
NOTICE
Ingersoll--Rand Company can bear no responsibility
for injury or damages resulting directly from the use of
non--approved repair parts.
Ingersoll--Rand Company service facilities and parts
are available worldwide. There are Ingersoll-- Rand
Company Construction Equipment Group Sales Of-
fices and authorized distributors located in the princi-
pal cities of the United States. In Canada our custom-
ers are serviced by the Canadian Ingersoll--Rand
Company, Limited. There are also Ingersoll--Rand In-
ternational autonomous companies and authorized
distributors located in the principal cities throughout
the free world.
Special order parts may not be included in this manual.
Contact the Mocksville Parts Department with the unit
serial number for assistance with these special parts.
DESCRIPTION
The illustrated parts breakdown illustrates and lists the
various assemblies, subassemblies and detailed parts
which make up this particular machine. This covers
the standard models and the more popular options
that are available.
A series of illustrations show each part distinctly and in
location relative to the other parts in the assembly.
The part number, the description of the part and the
quantity of parts required
are shown on each
illustration or on adjacent page.
The quantities
specified are the number of parts used per one
assembly and are not necessarily the total number of
parts used in the machine. Where no quantity is
specified the quantity is assumed to be one.
Each description of a part is based upon the “noun
first” method, i.e., the identifying noun or item name is
always the first part of the description. The noun name
is generally followed by a single descriptive modifier.
The descriptive modifier may be followed by words or
abbreviations such as upper, lower, inner, outer, front,
rear, RH, LH, etc. when they are essential.
In referring to the rear, the front or to either side of the
unit, always consider the
drawbar end
of the unit as
the
front.
Standing at the rear of the unit facing the
drawbar (front) will determine the right and left sides.
FASTENERS
Both SAE/inch and ISO/metric hardware have been
used in the design and assembly of these units. In the
disassembly and reassembly of parts, extreme care
must be taken to avoid damaging threads by the use of
wrong fasteners. In order to clarify the proper usage
and for exact replacement parts, all standard
fasteners have been identified by part number, size
and description. This will enable a customer to obtain
fasteners locally rather than ordering from the factory.
These parts are identified in tables that will be found at
the rear of the parts illustrations. Any fastener that has
not been identified by both part number and size is a
specially engineered part that must be ordered by part
number to obtain the exact replacement part.
Summary of Contents for P130WJDU
Page 28: ...Book 35393065 7 02 28 Figure Z...
