Ingersoll-Rand LT6K, Operation And Maintenance Manual, Page: 16 / 37

Operating Instructions
l23201387 (03/05) 15 Lightsource LT6K
Operation and Maintenance Manual
Set-up (prior to raising tower)
Figure 5
1. Inspect cables. Cables should not be frayed, cut,
abraded, or otherwise damaged. Replace
damaged cables.
2. Inspect springs and latch hardware. Replace any
damaged or broken springs or hardware.
3. Ensure no obstruction is overhead within 15
meters. Remove transport warning sign from end of
crossbar. Sign may be stored in tube on side of
mast during operation.
4. Remove pin. [Figure 5]
5. Be sure lamps are secure on cross bar and aim as
desired.
6. Extend all outriggers fully and insert locking pins
fully. Ensure drawbar jack and all outrigger and/or
jacks are firmly in contact with ground.
7. Level unit using jacks and bubble level indicator.
8. Jacks must support entire unit weight (tires off the
ground).
Before starting the engine
Before starting the engine carry out the following
cheecks:
1. Engine oil level: Add as required.
2. Engine coolant level: Add as required.
3. Fuel filter: Drain any accumulation of water. Clean
or replace element as required.
4. Air cleaner service indicator (if equipped):
Service when showing “red”.
5. Fuel level in tank: Fill, using CLEAN DIESEL fuel,
at the end of the day to minimize condensation.
6. Battery: Keep terminals clean and lightly greased.
7. Engine belts and hoses: Check for proper fit and/
or damage. Service as required.
8. Air Vents/Grilles: Both engine radiator and
generator cooling air. Check for obstructions
(leaves, paper, etc.)
9. Visual inspection: Check for excessive fluid leaks,
evidence of arcing around control panel, loose
wire-routing clamps, etc.
SCREW
PIN
IMPORTAMNT
Call qualified person to make electrical repairs.