USER MANUAL
Series HC
Reference No. 145 Final Rev 5
Page 8
September 2004
SECTION 1:
(Continued)
1.2.2
Safety tips for maintenance, inspection and assembly work
(Continued)
Attention!
−
Never make structural changes to the adsorption
dryer that are not specifically authorized by
Ingersoll-Rand!
−
Only use original spare and accessory parts!
−
Carry out maintenance work only when the
adsorption dryer is switched off, depressurized,
and disconnected from the electric power supply!
Attention!
−
Multiple power sources may exist in the electrical
panel. All possible power sources must be
disconnected before servicing dryer.
Advice: Refer to the desiccant material safety data sheet (MSDS) when
installing or disposing of desiccant, which can be found in
Section 7 of this User Manual.
Danger!
Wear protective goggles and mask when working with the desiccant!
Advice for protection:
−
If desiccant comes into contact with the eyes, rinse eyes immediately with large
amounts of clear water.
−
If the desiccant is spilled, clean up with effort to minimize the formation of dust.
−
In case of fire, there is no restriction on the use of fire extinguishing material.
−
A small dust mask must be worn.
1.3
PERSONNEL QUALIFICATION
The personnel involved in operation, maintenance, inspection, and assembly must
have the corresponding qualifications to do this work. Areas of responsibility and
supervision of the personnel must be precisely established by the operator. Should
the personnel not possess the necessary knowledge, then they must be trained and
instructed. If need be, this training may be carried out by the manufacturer / supplier
at the request of the operator of the adsorption dryer. Further, the operator is to
make sure that the personnel completely understand the contents of the technical
manual.
