3
PLACING TOOL IN SERVICE
TOOL OPERATION
Sand using any portion of the exposed Sanding Belt. For
best results, sand on that portion of the Belt being pulled by
the Drive Wheel.
LUBRICATION
Ingersoll–Rand No. 10
Ingersoll–Rand No. 67
Ingersoll–Rand No. 50
Ingersoll–Rand No. 68
Ingersoll–Rand No. 63
Ingersoll–Rand No. 77
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
USA – No. C28–04–FKG0–28
After each two hours of operation, if an air line lubricator
is not used, inject 1/2 to 1 cc of Ingersoll–Rand No. 10 Oil
into the Air Inlet.
After each eight hours of operation, inject approximately
1 cc of Ingersoll–Rand No. 67 or Ingersoll–Rand No. 77
Grease into the Angle Head Grease Fitting. Excessive
lubrication will cause grease to work out around the
Arbor.
Do not mark any nonmetallic surface of this tool with
customer identification codes. Such action could affect
tool performance.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905–1)
HOW TO ORDER SERIES CA ANGLE BELT SANDERS
ANGLE BELT SANDERS WITH 12” x 1/2” BELT
Model
Arbor Speed
Belt Speed
rpm
sfpm
CA200RS812 (Rear Exhaust)
20,000
4,500
CA120RS812 (Rear Exhaust)
12,000
2,700
ANGLE BELT SANDERS WITH 18” x 1/4” BELT
CA200RS418 (Rear Exhaust)
20,000
4,500
CA120RS418 (Rear Exhaust)
12,000
2,700
ANGLE BELT SANDERS WITH 18” x 1/2” BELT
CA200RS818 (Rear Exhaust)
20,000
4,500
CA120RS818 (Rear Exhaust)
12,000
2,700
